ACCESSORIES
These are the available accessories that are tailored for our Polycarbonate Sheets.
Aluminum H-Connector
It is a powder coated aluminum material used to connecting 2 sheets of Twinwall or Solid Polycarbonate Sheets. There are 2 strips of neoprene rubber embedded into the entire H-Connector length used to cushion the aluminum material from direct contact to the polycarbonate sheet. The rubber also serves as an additional protection to prevent water penetration.
Polycarbonate U-Clip
Made of polycarbonate material, this accessory is usually applied on the edges of the Twinwall Sheets and Solid Polycarbonate sheets to complete the aesthetic appeal of the entire installation. The U-Clips are also used to shield and protect the porous filtering tape from deterioration and peel off. More importantly, U-Clips are used for safety reasons as polycarbonate edges are sharp and may cause physical injuries.
Tapes
Porous Filtering Tape
Is a rolled tape with micro-holes that makes the texture porous. This polycarbonate installation accessory is applied on the lower part of entire roofing’s slope. This is used only for Twinwall sheets to prevent the entry of dirt into the hollow part of the sheets and to cause the Twinwall sheets to “breathe” and prevent mold growth.
Specs
Size |
|---|
1in X 10yds |
Stainless Tex Screw
Stainless Tex Screw with Neoprene Washer
Stainless Tex Screw w/ Neoprene Washer is a hexagonal stainless screw that is primarily used for the installation of twinwall, corrugated and solid polycarbonate sheets, as well as other roofing materials. The entire tex screw set comes with a neoprene washer for thermal expansion cushioning. There are 2 dimensions available, depending on roofing profile or frame thickness.
Specs
Size |
|---|
¼” X 1 ½” X 5.5mm |
¼” X 2” X 5.5mm |
Stainless Tex Screw with Neoprene Rubber
A pan head stainless screw that is used for attaching flat sheets such as Twinwall sheets or Solid Polycarbonate sheets directly into the supporting frame or purlin. The entire tex screw set comes with a neoprene rubber that acts as cushion for thermal expansion of polycarbonate sheets and serves as additional protection to prevent leaks from seeping through the screws.
Specs
Size |
|---|
1” X 4.1mm |
1 ½” X 4.1mm |
Sunshield Neutral Cure Silicone Sealant
Neutral cure sealants are specifically formulated to be gentle and mild. It is used to seal gaps or joints between the aluminum h-connectors and the polycarbonate sheets. It is also used to prevent water from penetrating inside the material without harming your polycarbonate materials.